Installing Serverview; Setting Required After Installation - Fujitsu Primergy RX600 S2 User Manual

Chapter 6 High Reliability Tools
●
Voltage Monitoring
ServerView monitors the voltage. In an environment where ServerView is not applied, voltage
irregularities cannot be detected during operation. In order to detect the problem, the server must reboot
to run the BIOS Setup Utility or the Server Management Tools. As leaving the voltage surges, the server
may malfunction or data loss may occur.
●
Power Supply Monitoring
ServerView monitors the power supply. In an environment where ServerView is not applied, power
supply irregularities cannot be detected during operation. In order to detect the problem, the server must
reboot to run the BIOS Setup Utility or the Server Management Tools. System stops due to power supply
failures cannot be prevented.

6.2.1 Installing ServerView

●
When Installed Using ServerStart
If the OS is implemented and setup using ServerStart, ServerView will be installed at once with the OS
and other high reliability tools.
●
Windows Server 2003 x64, Linux (Manual Install)
ServerView cannot be installed using ServerStart. To install ServerView into Windows Server 2003 x64
or a Linux system, refer to "Installing" in "ServerView User's Guide".
Be sure to install SNMP service before installing ServerView.
■ When an error screen appears after ServerView installation
(Windows Server 2003 only)
If Windows Server 2003 Service Pack 1 is applied, the following message may appear on restarting after
installing/uninstalling ServerView.
In order to protect the computer, this program is terminated by
Windows.
Name: SNMP Service
There is no problem with operations. Click [Close Message] to close the message.

6.2.2 Setting Required after Installation

Perform necessary operations after ServerView installation referring to "2.4 Checking after Installation"
in "ServerView User's Guide".
174