Fujitsu Primergy RX600 S2 User Manual page 123

3
The [Windows 2000 Server Setup] window appears.
Immediately, the following message appears at the bottom of the window. Press the [F6] key.
Press F6 if you need to install a third party SCSI or RAID
driver ...
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.
4
Install the Drivers manually.
1. When the following message appears, press the [S] key.
To specify additional SCSI adapters, CD-ROM drives,
or special disk controllers for use with Windows 2000,
including those for which you have a device
support disk from a mass storage device
manufacturer, press S.
2. When the "Please insert the disk labeled Manufacturer-supplied hardware support
disk into Drive A:" message appears, insert the driver disk created from the
ServerStart CD-ROM and press the [Enter] key.
The following message appears.
You have chosen to configure a SCSI Adapter for use
with Windows 2000, using a device support disk
provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following
list, or press ESC to return to the previous screen.
3. Select following item and press the [Enter] key.
LSI MEGARAID Products for Windows 2000
4. Follow instructions in the window to perform installation.
When a message prompting you to insert a floppy disk appears, insert the proper
driver disk and press the [Enter] key.
Repeat these procedures to install a driver for another card.
5
Follow the instructions from the setup program to continue the installation
procedures.
Cautions on Restarting
In the course of installation, a message appears to indicate that the setup program restarts.
Wait until it restarts automatically.
6
Apply Windows 2000 Service Pack.
For details, refer to the description in the window.
PRIMERGY RX600 S2 User's Guide
4
123