Installing Windows 2000 Server - Fujitsu PRIMERGY RX600 S3 User Manual

4.2.3 Installing Windows 2000 Server

1
Create driver disks.
Prepare necessary drivers before installing Windows 2000 Server.
Some drivers used with Windows 2000 Server are created from the ServerStart CD-ROM. For
how to create driver disks, refer to "4.1 Creating Driver Disks" ( pg.114).
2
Turned on the server and configure RAID. If you do not configure RAID,
proceed to step 3.
Turn on the server to display the following message and press the [Ctrl] + [H] key to start up
WebBIOS.
Press <Ctrl><H> for WebBIOS
The array system is configured by using WebBIOS. For more details, refer to "Onboard SCSI
RAID User's Guide".
Turn off the server after configuring the array system.
3
Insert the Windows 2000 Server CD-ROM.
Turn on the server and insert the Windows 2000 Server CD-ROM immediately into the CD-ROM
drive. Check there are no floppy disks in the floppy disk drive. When the active area is specified
on the hard disk, the following message appears.
Press any key to boot from CD....
Pressing any key while this message is displayed boots the system from the CD-ROM.
4
The [Windows 2000 Server Setup] window appears.
Immediately, the following message appears at the bottom of the window. Press the [F6] key.
Press F6 if you need to install a third party SCSI or RAID
driver ...
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.
5
Install the Drivers manually.
1. When the following message appears, press the [S] key.
To specify additional SCSI adapters, CD-ROM drives,
or special disk controllers for use with Windows 2000,
including those for which you have a device
support disk from a mass storage device
manufacturer, press S.
PRIMERGY RX600 S3 User's Guide
4
125