Table of Contents
Advertisement
Chapter 5 Operations after OS Installation
5.5 Notes Before Operating the
Server
This section explains the settings required before starting to operate the server.
For the respective settings, refer to "First Step Guide".
• If a LAN card was added, install a driver according to "4.3 Installing the LAN Driver" ( pg.126).
• When connecting a SCSI optional device (such as a hard disk cabinet or DAT), connect it according
to "Chapter 7 Installing Internal Options" ( pg.177).
• For the settings for the installed applications supplied with the product, refer to the manuals of each
application.
5.5.1 Updating the System
■ Windows Update
The system being used must be updated to prevent potential problems in the system.
Executing Windows Update can automatically search the latest version of QFE applicable to the OS and
update the system to the latest status. Execute Windows Update periodically.
Executing Windows Update requires a network environment connectable to the Internet.
5.5.2 Auto-run Function from CD-ROM Drives
Perform the following procedures to change the settings of the auto-run function from the CD-ROM
drives after server installation:
1
Make the registry editable, and change the value of AutoRun of the following
registry key:
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\CDRom
Set the value of Autorun to "1" to enable auto-run, and set the value to "0" to disable auto-run.
2
Restart the system.
The setting is enabled after the system is restarted.
5.5.3 Drive Letter Assignment in Expert Mode
In expert mode, you cannot specify a drive letter to a particular partition arbitrarily. Drive letters
specified with Disk Manager in expert mode will be sequentially assigned from the first partition with
"C, D, E..." when installation is completed, and an unused drive letter will be assigned to the CD-ROM
drive.
To change the drive letter, perform the following procedures after installation.
152
Advertisement
Table of Contents
Troubleshooting
