Starting Manual Installation; Installing Windows Server 2003 X64 - Fujitsu PRIMERGY TX120 User Manual

4.2 Starting Manual Installation

This section explains how to install the OS manually.
When starting the server without setting the floppy disk in the FDD unit (USB), BIOS does not
recognize the FDD unit (USB). Make sure to connect the FDD unit (USB) and set the floppy disk
before starting the server. For details, refer to "Appendix E External Floppy Disk Drive (USB) Notes on
Usage" ( pg.216).

4.2.1 Installing Windows Server 2003 x64

For details on the OS settings, refer to the following URL.
http://www.microsoft.com/technet/prodtechnol/exchange/2003/Library/default.mspx
1
Create driver disks.
Prepare necessary drivers before installing Windows Server 2003 x64.
Some drivers are created from PRIMERGY Startup Disc.
For how to create driver disks, refer to "4.1 Creating Driver Disks" ( pg.70).
2
Turn on the server and configure RAID. If RAID is not required to be
configured, proceed to Step 3.
Turn on the server to display the following message and press the [Ctrl] + [C] key to start up
RAID BIOS Utility.
Press Ctrl C to start LSI Logic Configuration Utility
Configure the array system using the RAID BIOS Utility. For more details, refer to "Integrated
Mirroring SAS User's Guide" in Array Controller Document & Tool CD.
Turn off the server after configuring the array system.
3
Prepare the Windows Server 2003 x64 CD/DVD.
After setting the driver disk created in advance, turn on the server and insert the Windows Server
2003 x64 CD/DVD immediately into the CD/DVD drive. When the active area is specified on the
hard disk, the following message appears.
Press any key to boot from CD....
Pressing any key while this message is displayed boots the system from the CD/DVD.
PRIMERGY TX120 User's Guide
75