Fujitsu Primergy RX600 S2 User Manual page 89

●
Remote Installation Using a PXE Server
In remote installation using a PXE server, the network startup (PXE) function of the PXE server starts
up the target server and performs installation in preconfiguration mode. This method is used when the
target server does not have a CD-ROM or floppy disk drive.
Target server
In addition to the PXE server, a "remote resource server" that stores remote resources and a "DHCP
server" that performs the DHCP service are required for remote installation using a PXE server. When
you have only one server, store remote resources on the PXE server to install the DHCP service. When
you have multiple servers, select one for performing the DHCP service and another for storing remote
resources.
●
Remote Installation Using a Remote Resource Server
In remote installation using a remote resource server, ServerStart starts up on the target server.
Procedures for starting installation are the same as those in normal installation (preconfiguration,
guided, and expert modes). Once installation started, resources necessary for installation are provided
from the remote resource server. Thus, procedures such as inserting a CR-ROM are not necessary.
Active ServerStart
and start installation
Target server
Installation
using ServerStart
Activated by IP address,
1)
boot image
2) Request resources
PXE server
3) Supply resources
1) Request resources
2) Supply resources
PRIMERGY RX600 S2 User's Guide
- OS
- Service Pack
- Application
etc.
- OS
- Service Pack
- Application
etc.
Remote resource server
3
89