Fujitsu Primergy RX600 S2 User Manual page 261

Error
Message
Code
0146 Insufficient Memory to Shadow PCI
ROM
8110-8113 Processor n Internal error (IERR)
8120-8123 Processor n Thermal Trip Error
8130-8133 Processor n Disabled
8140-8143 Processor n Failed FRB-3 timer
8160-8163 Processor n unable to apply microcode
update
8170-8173 Processor n failed BIST
8180-8183 BIOS does not support the current
stepping for processor n
8190 Watchdog Timer Failed on Last Boot
8198 Operating system boot watchdog timer
failure
table: List of POST Errors
PCI ROM error. Check that the PCI card is mounted
properly. If the message still appears, the PCI card or the
PCI slot must be replaced. If the message still appears
after the replacement, the baseboard must be replaced.
Contact an office listed in the "Contact Information" of
"Start Guide".
CPU error ("n" in the message represents the CPU socket
number). Set [Processor Retest] on the [Processor] menu
to [Enabled] in the BIOS Setup Utility, reboot the system,
and confirm the CPU connection. If the message still
appears, the CPU must be replaced. If the message still
appears after the replacement, the baseboard must be
replaced. Contact an office listed in the "Contact
Information" of "Start Guide".
CPU error ("n" in the message represents the CPU socket
number). After confirming that the heat sink, the fan, and
the airflow work normally, set [Processor Retest] on the
[Processor] menu to [Enabled] in the BIOS Setup Utility,
and reboot the system. If the message still appears, the
CPU must be replaced.
CPU error ("n" in the message represents the CPU socket
number). After confirming whether there are any errors
reported in the system event log, set [Processor Retest] on
the [Processor] menu to [Enabled] in the BIOS Setup
Utility, and reboot the system. If the message still
appears, replace the CPU. If the message still appears
after the replacement, the baseboard must be replaced.
Contact an office listed in the "Contact Information" of
"Start Guide".
CPU error ("n" in the message represents the CPU socket
number). Start the BIOS Setup Utility, set [Processor
Retest] on the [Processor] menu to [Enabled], and reboot
the system. If the message still appears, replace the CPU.
If the message still appears after the replacement, the
baseboard must be replaced. Contact an office listed in
the "Contact Information" of "Start Guide".
CPU error ("n" in the message represents the CPU socket
number). Start the BIOS Setup Utility, set [Processor
Retest] on the [Processor] menu to [Enabled], and reboot
the system. If the message still appears, replace the CPU.
If the message still appears after the replacement, the
baseboard must be replaced. Contact an office listed in
the "Contact Information" of "Start Guide".
Boot Watchdog Timer has timed out. View the system
event log and confirm whether any errors have been
recorded.
PRIMERGY RX600 S2 User's Guide
Description
9
261