Loading Single Sheets - GRAPHTEC CE2000-60 User Manual

6
Step
After the medium size has been detected, the cutting plotter awaits cutting data.
If the INTERFACE conditions and COMMAND mode have not been selected yet, select these settings
at this time (see Section 3.4, "Selecting the COMMAND Mode and INTERFACE Conditions"). If they
have already been set, proceed to adjust the cutter pen. After the cutter pen has been adjusted (see
Chapter 4, "PREPARING FOR A CUTTING OPERATION"), the cutting plotter is ready to perform cutting
so send cutting data from your application software at the computer.

3.3.2 Loading Single Sheets

CE2000-60
1
Step
Lower the media set lever to raise the push rollers.
3
Step
Adjust the position of the right and left push
rollers to suit the width of the medium. Position
each push roller at its corresponding edge of
the medium so that it is above the grit roller.
Move the push rollers so that they are posi-
tioned inside the push roller alignment marks
provided. (To move the push rollers, the media
set lever must be in the lowered position.)
2
Step
While using the front and rear medium alignment
scales as guidelines, load one sheet of the medium
so that its leading and trailing areas are positioned
identically.
Medium alignment scales
3 – 8