Specifying The Cutter Offset - GRAPHTEC CE2000-60 User Manual

4.4.4 Specifying the CUTTER OFFSET

This setting adjusts the offset of the cutter blade according to the currently selected blade type. If the
blade type is set to PEN, a plotting pen can be used. When a cutter blade designation or OTHER is
selected, a cutter pen can be used. Because the tip of the blade mounted in the cutter pen plunger
is not positioned at the center of the pen, the cutting position is adjusted by specifying the CUTTER
OFFSET setting.
Since the cutting plotter has been preset with the optimum CUTTER OFFSET values for the CB09UA
and CB15U supersteel blade types, the optimum CUTTER OFFSET value can be easily selected by
simply selecting the corresponding blade number. Fine adjustment of these two settings is also possible
within a ±5 range.
1
Step
After selecting the desired set of cutting conditions, check that the cutting plotter is in READY or PAUSE
status and then press the
TEST CUT
PEN SETTINGS
2
Step
F2/TEST
Press the key (PEN SETTINGS) again to
display the menu below.
SPEED
PEN FORCE
4
Step
Press the key (CUTTER OFFSET) to display the menu below.
F1/ORIGIN
CUTTER OFFSET
09U
At the above menu, use the
Use the or key to select the blade type (09U, 15U, OTHER, or PEN).
When a blade number (09U or 15U) is displayed, the
the setting within a ±5 range.
When OTHER is displayed, the
within a range of 1 to 45.
When PEN is displayed, no CUTTER OFFSET setting is required.
When the displayed CUTTER OFFSET value is satisfactory, press the
5
Step
Consecutively press the
key to display the menu below.
F2/TEST
0
or key to change the CUTTER OFFSET setting.
and keys can be used to specify the CUTTER OFFSET value
key until the READY or PAUSE menu reappears.
NEXT PAGE
3
Step
Press the
NEXT PAGE
CUTTER OFFSET
QUALITY
and keys can be used to finely adjust
4 – 10
key to display the menu below.
ENTER
key to register your setting.