Specifying The - GRAPHTEC CE2000-60 User Manual

6.6 Specifying the Page Length
This function lets you specify the length of each page. When using a roll medium, the PAGE LENGTH
setting corresponds to the length per page. Before performing long-axis cutting of an image longer
than two meters, be sure to specify the PAGE LENGTH setting.
1
Step
PAUSE
Press the key to enter the PAUSE mode.
2
Step
Press the key until the menu below ap-
NEXT PAGE
pears.
FILM
FUNCTIONS
4
Step
Press the key to display the menu below.
NEXT PAGE
PAGE LENGTH
PLOT AREA
5
Step
Press the
F1/ORIGIN
PAGE LENGTH
L= 020 0mm
Use the or key to shift the blinking cursor in the corresponding direction and select the desired
digit. Use the and
6
Step
When the displayed setting is satisfactory, press
ENTER
the key to register your setting.
NOTE : • The PAGE LENGTH setting is retained in the cutting plotter's internal memory, even
while the cutting plotter is turned off.
• The cutting plotter's distance precision is guaranteed for page feed operations up to
two meters. In the case of an image longer than two meters, long-axis cutting can
be performed for up to 50 meters in the feeding direction. (This maximum distance
is based on the use of 3M plastic-backed film with the cutting conditions of: SPEED
= 30 or less, QUALITY = 1.)
• In the case of long-axis cutting, be especially careful when loading color adhesive-
backed film. If the film is loaded at even a slight angle, the film may come loose from
the rollers which hold it in place.
• For long-axis cutting using roll film, pull out the length of film you intend to use before
you load the film.
key (PAGE LENGTH) to display the menu below.
keys to change the numeric value of the digit selected by the cursor.
3
Step
Press the
F1/ORIGIN
below.
AXIS ADJ.
DIST ADJ.
7
Step
PAUSE
Press the key to cancel the PAUSE mode.
6 – 9
key (FILM) to display the menu