5.2 Moving the Pen Carriage in +100-mm Steps
This function lets you move the pen carriage from its current position in +100-mm steps along the X
and Y axes.
To Move the Pen Carriage
While the READY or PAUSE menu is being displayed, hold down the
key. If you repeat this operation, the pen carriage is further moved in +100-mm steps each time.
To Return the Pen Carriage to its Initial Position
While the READY or PAUSE menu is being displayed, hold down the
key.
5.3 Clearing Data from the Internal Memory
This function clears the cutting plotter's internal memory of data that was sent from the computer. Use
this function when you wish to discontinue a cutting operation that is in progress.
1
Step
PAUSE
Press the
key to enter PAUSE status.
3
Step
Press the
key until the menu below appears.
NEXT PAGE
CLEAR BUFFER
FEED
4
Step
Press the
key (CLEAR BUFFER) to display the prompt below.
F1/ORIGIN
CLEAR
CANCEL
5
Step
Press the
key (CLEAR) to clear the buffer.
F1/ORIGIN
F2/TEST
Press the
key (CANCEL) to cancel the CLEAR BUFFER operation.
6
Step
PAUSE
Press the
key to return to READY status.
CLEAR
OK?
2
Step
If data is being sent to the cutting plotter from the
computer, stop the data transmission.
5 – 3
ENTER
key while you press the
ENTER
key while you press the