Using The Copy Function - GRAPHTEC CE2000-60 User Manual

6.2 Using the COPY Function

Use the COPY function to make duplicate copies of cutting data that has been sent from the computer
and retained in the cutting plotter's internal memory.
Initial cutting operation's origin
1
Step
Send the data to be copied to the cutting plotter and perform a single cutting operation with that data.
2
Step
Use the POSITION keys to move the cutter pen to the desired origin of (the starting position for cutting/
plotting by) the COPY operation.
3
Step
PAUSE
Press the key to enter the PAUSE mode.
4
Step
Press the key until the menu below ap-
NEXT PAGE
pears.
FILM
FUNCTIONS
6
Step
F2/TEST
Press the key (COPY) to display the menu below.
COPY MODE
COUNT 1
If the data to be copied exceeds the effective cutting area, the warning message below appears.
CANNOT COPY
If this message appears, either use the POSITION keys to reposition the COPY operation's origin or
load film with an area large enough to contain the target data.
3rd copy
6th copy
2nd copy
5th copy
1st copy
4th copy
COPY operation's origin
Step
Press the
the menu below.
6 – 3
5
F2/TEST
key (FUNCTIONS) to display
ROTATE
COPY