GRAPHTEC CE2000-60 User Manual page 26

CE2000-120
1
Step
Lower the media set lever to raise the push
rollers.
2
Step
Trap the medium's edges between the two
stoppers and then firmly fix each stopper in
place by tightening its plastic hexagon screw.
Gently pull the leading edge of the film toward
you to remove any slack in the film as it is fed
along the conveyance path from the main unit.
NOTE: In the case of a medium with a paper core that extends beyond the side edges of the
medium itself, the medium may ride over the stoppers when the remaining supply of the
medium runs low. When using this type of medium, be sure to replace it with a new roll
right before the medium starts riding over the stoppers.
3
Step
At this point, pull the leading edge out of the
front of the cutting plotter so that it completely
covers the media sensor. If its leading edge
has been pulled out so much that slack cannot
be provided at the back of the plotter, turn the
roll to adjust the length of the medium in front
of the cutting plotter by retracting the leading
edge.
Stopper
3 – 6
Media sensor