Using The Dump Mode - GRAPHTEC CE2000-60 User Manual

9.3 Using the DUMP Mode

In contrast with the SELF TEST mode which checks the operation of the cutting plotter itself, this function
prints the data received by the cutting plotter from the computer as codes so you can check whether
data transfer is being properly conducted. If the data printed is not identical to the data sent from
the computer, check that you are using the correct interface cable and that the cable is properly
connected. If you are using the RS-232C serial interface, also check that the proper interface conditions
have been set at both the cutting plotter and the computer.
1
Step
Mount a plotting pen (not a cutter pen) at the cutting plotter's pen holder and then set the pen type,
FORCE, SPEED, and QUALITY to suit the pen mounted.
2
Step
Load paper of at least A4 size in the cutting plotter.
3
Step
PAUSE
Press the key to enter the PAUSE mode.
4
Step
Press the key until the menu below ap-
NEXT PAGE
pears.
INTERFACE
PEN UP/DOWN
5
Step
Simultaneously press the
display the menu below.
PEN UP SPEED
OFFSET FORCE
9
Step
Press the
F1/ORIGIN
ON DUMP
OFF
The blinking square cursor indicates the currently selected DUMP mode setting.
To enable the DUMP mode, press the
To disable the DUMP mode, press the
When the cursor appears in front of the desired setting, press the
mode setting.
ENTER
and keys to
NEXT PAGE
key (DUMP) to display the menu below.
6
Step
Press the
NEXT PAGE
pears.
7
Step
Press the
menu below.
8
Step
Press the NEXT PAGE to display the menu below.
key to move the blinking cursor to the ON position.
F1/ORIGIN
F2/TEST key to move the blinking cursor to the OFF position.
9 – 5
key until the menu below ap-
TEST
LENGTH UNIT
key (TEST) to display the
F1/ORIGIN
CONDITION
SELF TEST
DUMP
CUT DEMO
ENTER
key to register your DUMP