GRAPHTEC CE2000-60 User Manual page 8

Cutting plotter
Table of Contents

Advertisement

For CE2000-60 models
WARNING:
Only computers or peripherals (computer input/output devices, terminals, printers, etc.) certified as
complying with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, may be
attached to this product when this product is operated in a residential environment. Operation with
non-certified peripherals is likely to result in interference to radio and TV.
The United States Federal Communications Commission has specified that the following notice must
be brought to the attention of users of this product.
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY
INTERFERENCE STATEMENT
"This equipment has been tested and found to comply with the limits for a Class B digital device pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct interference
by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help."
USE SHIELDED CABLES
To comply with FCC Class B requirements, all external data interface cables and connectors must be
properly shielded and grounded. Proper cables and connectors are available from GRAPHTEC's
authorized dealers or manufacturers of computers or peripherals.
GRAPHTEC is not responsible for any radio or television interference caused by using cables and
connectors other than those recommended or by unauthorized changes or modifications to this equip-
ment. Unauthorized changes or modifications could void the user's authority to operate the equipment.
vi

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CE2000-60 and is the answer not in the manual?

This manual is also suitable for:

Ce200-120

Table of Contents

Save PDF