Specifying The Pen Up Speed - GRAPHTEC CE2000-60 User Manual

7.1 Specifying the PEN UP SPEED

This function is used to specify the travelling speed of the cutter pen in raised status. It can be specified
independently of the cutting SPEED function. When the PEN UP SPEED is high, the cutter pen travels
faster while in raised status to shorten the overall cutting time. Your cutting plotter comes with its PEN
UP SPEED set to AUTO, which selects the same speed as the cutting SPEED function (the cutter
pen is in lowered status). Note that if you perform long-axis cutting of film with a high PEN UP SPEED
setting, the film is likely to become jammed.
1
Step
PAUSE
Press the key to enter PAUSE mode.
2
Step
Press the key until the menu below appears.
NEXT PAGE
INTERFACE
PEN UP/DOWN
3
Step
Simultaneously press the
PEN UP SPEED
OFFSET FORCE
4
Step
Press the key (PEN UP SPEED) to display the menu below.
F1/ORIGIN
PEN UP SPEED
AUTO
Use the and
register your setting.
The PEN UP SPEED can be set to AUTO (the PEN UP SPEED setting becomes identical to the SPEED
setting) or to 10, 20, 30, or 60 cm/s.
5
Step
PAUSE
Press the key to cancel the PAUSE mode.
NOTE : The PEN UP SPEED setting is retained in the cutting plotter's internal memory, even
while the cutting plotter is turned off.
ENTER
and keys to display the menu below.
NEXT PAGE
keys to select the desired PEN UP SPEED and then press the
7 – 2
ENTER
key to