Enabling The Auto Pre Feed Mode - GRAPHTEC CE2000-60 User Manual

6.3 Enabling the AUTO PRE FEED Mode

When the CE2000 first receives data while the AUTO PRE FEED setting is ON, it automatically feeds
the medium forward and backward by the specified distance. This operation marks the cutting film
with the tracks of the grit rollers and thus prevents the film from slipping out of place. When using
roll film, moreover, the CE2000 automatically advances the leading edge of the medium.
1
Step
PAUSE
Press the key to enter the PAUSE mode.
2
Step
Press the key until the menu below ap-
NEXT PAGE
pears.
FILM
FUNCTIONS
4
Step
Press the
F1/ORIGIN
ON
OFF
5
Step
To enable the AUTO PRE FEED mode, press the
ON position.
To disable the AUTO PRE FEED mode, press the
OFF position.
When the cursor appears in front of the desired setting, press the
PRE FEED setting.
6
Step
If you selected the ON setting in Step 5, the message below appears.
AUTO PRE FEED
FEED LENGTH 1m
Use the and keys to specify the FEED LENGTH setting. When the displayed value is satisfactory,
ENTER
press the key to register your FEED LENGTH setting.
7
Step
PAUSE
Press the key again to cancel the PAUSE mode.
key (AUTO PRE FEED) to display the menu below.
PRE FEED
3
Step
After pressing the
press the
NEXT PAGE
below.
AUTO PRE FEED
key to move the blinking cursor to the
F1/ORIGIN
F2/TEST
key to move the blinking cursor to the
ENTER
6 – 5
F2/TEST
key (FUNCTIONS),
key once to display the menu
key to register your AUTO