GRAPHTEC CE2000-60 User Manual page 6

Safety Precautions (Continued)
Do not use or store the cutting plotter in a location exposed
to direct sunlight or the direct draft of an air conditioner or
heater.
• Such location may impair the performance of the cutting plotter.
Do not use the cutting plotter in an excessively dusty or humid
location.
• Such location may impair the performance of the cutting plotter.
Do not place any receptacle containing water or other fluid
on top of the cutting plotter.
• Fluid falling inside the cutting plotter may cause electrical shock
or a fire hazard due to current leakage.
Do not use the cutting plotter in a location subject to excessive
mechanical vibration or electrical noise.
• Such location may impair the performance of the cutting plotter.
When disconnecting the power cord or an interface cable, do
not pull on the cord/cable.
• Such action will damage the cord/cable, resulting in a fire hazard
or electrical shock. Be sure to hold the power cord's plug or
the interface cable's connector.
If water or foreign matter enters inside the cutting plotter, do
not continue using it. Turn off its power and unplug its power
cord from the electrical socket.
• Use of the cutting plotter in such status may result in electrical
shock or a fire hazard due to current leakage.
• Contact your sales representative or nearest Graphtec vendor
to request repair.
CAUTION
Prohibited
Prohibited
Avoid water
Beware of electrical shock
Unplug the power
cord from the socket
iv
Prohibited
Prohibited