Aligning The Coordinate Axes - GRAPHTEC CE2000-60 User Manual

6.5 Aligning the Coordinate Axes

When loading new film, the AXIS ADJ. function is used to reposition the coordinate axes to compensate
for any deviation in the coordinate axes and origin between the cutting plotter and the medium which
has previously been cut or plotted. This function lets you re-align the cutting plotter's coordinate axes
to match those of a previously cut or plotted medium. To make it easier to specify the AXIS ADJ.
settings, first plot a figure that clearly indicates the origin point and the orientation of the X axis. Be
sure to perform plotting within the effective cutting area so that the AXIS ADJ. settings can be specified
even if the origin and the line indicating the X axis are positioned at an angle. If the origin and the
line indicating the X axis line are plotted near the boundaries of the effective cutting area, the resulting
AXIS ADJ. settings may be outside of the effective cutting area such that the coordinate axes cannot
be re-aligned.
1
Step
PAUSE
Press the key to enter the PAUSE mode.
2
Step
Press the key until the menu below appears.
NEXT PAGE
FILM
FUNCTIONS
3
Step
Press the
F1/ORIGIN
AXIS ADJ.
DIST ADJ.
4
Step
Press the
F1/ORIGIN
ADJ. PT 1
( 0,
Use the POSITION keys to move the cutter pen to the desired ADJ. PT 1 position (the initial point
from which you started plotting). The coordinate values displayed at such time represent the relative
distances from the cutter pen's currently selected origin.
5
Step
After the cutter pen is at the desired position, press the
of rotation for the new origin and the X axis. The menu shown in Step 6 also appears.
key (FILM) to display the menu below.
key (AXIS ADJ.) to display the menu below.
0)
ENTER
key to set this position as the center
6 – 7