GRAPHTEC CE2000-60 User Manual page 27

4
Step
Adjust the position of the right and left
push rollers to suit the width of the
medium. Position each push roller at its
corresponding edge of the medium so
that it is above the grit roller. Move the
push rollers so that they are positioned
inside the push roller alignment marks
provided. (To move the push rollers,
the media set lever must be in lowered
position.)
Position the push roller (2) so that it is at the midpoint of the film and is also over the center grit roller.
The film is held in place using the three rollers called push rollers (1), (2), and (3).
Push roller (3)
Film
Position the push roller (2) so that it is at the midpoint of the
film and is also over the center grit roller.
If the "RELOAD MEDIA!" message appears when you lower the media set lever, the right pinch roller
is not positioned over the wider grit roller on the right. This message also appears if the left pinch
roller is not positioned over a grit roller or is positioned over the wider grit roller on the right. Check
that the right pinch roller is positioned over the wider grit roller on the right and that the left pinch roller
is positioned over a grit roller other than the wider one on the right.
5
Step
If the cutting plotter has already been turned on when the push rollers are lowered by raising the media
set lever, a menu for selecting the media mode appears. Select the media mode (ROLL 1 or ROLL
2) to suit the roll medium you have just loaded.
ROLL 1
ROLL 2
To select ROLL 1, press the
To select ROLL 2, press the
When ROLL 1 is selected, the leading edge and side edges of the medium are detected. Select this
mode when you wish to begin cutting from the medium's leading edge. In this case, the origin point
is positioned along the leading edge.
When ROLL 2 is selected, only the medium's side edges are detected. Select this mode when you
wish to begin cutting at a point past the medium's leading edge. In this case, the position of the pen
carriage at the time the medium was loaded becomes the origin point.
Push roller
Push roller(1)
Grit roller
key.
F1/ORIGIN
F2/TEST
key.
Similar to the push rollers (1) and (3) in the figure below,
position the push roller (2) over a grit roller.
3 – 7