Loading Media (Paper); Loading Roll Media - GRAPHTEC CE6000-120AP Setup Manual

2. Loading Media (Paper)

Both roll media and sheet media can be used with the CE6000-120AP. (For more information about loading a sheet media, please see the
User's Manual (PDF). Load the media according to the instructions given for each type. Use the grit roller on the right side of the media (looking
from the front) as a guide when setting it in the media sensor. Afterwards, adjust the push roller so that it's lined up with the side of the media.
For details, see CE6000-120AP User's Manual (PDF).
CAUTION
Notes when using roll media
•
Make sure to reduce the maximum feed rate if there is any trouble with paper feed not using the basket.
•
Take all cut/plotted paper out of the basket; paper left in the basket may cause deviations and affect performance for
subsequent jobs.

Loading Roll Media

1
Set the media flange and paper to the stock shaft and insert in the direction of
the paper.
Media flange
Stock shaft
Determine the desired position, and then tighten the flange screw.
Set the position measurement for the media flange as per the following guidelines
in when using paper with a width of 1200 mm.
If using paper of a different width loosens the flange screw, adjust the position of
the grit roller, then re-tighten the flange screw.
Media
Media flange
Stock shaft
Flange
screw
Approx. 100mm
2
Lowering the lever releases the stopper lock.
Media flange
Groove
Grooved portion of the
components should be set so
that the grooves contact the
receiving end of the roller.
Flange screw
Lever

Supplement
The following figure shows the direction of the
roll media when loading it.