Rotating The Coordinate Axes - GRAPHTEC CE2000-60 User Manual

6.1 Rotating the Coordinate Axes

The ROTATE function allows you to rotate the initial cutting point and the coordinate system as shown
in the figure below. The ROTATE setting is retained in the cutting plotter's internal memory, even while
the cutting plotter is turned off.
1
Step
PAUSE
Press the key to enter the PAUSE mode.
2
Step
Press the key until the menu below ap-
NEXT PAGE
pears.
FILM
FUNCTIONS
4
Step
Press the key (ROTATE) to display the menu below.
F1/ORIGIN
ON
OFF
The flashing cursor indicates the currently selected ROTATE setting.
5
Step
To switch the ROTATE setting to ON, press the
position.
To switch the ROTATE setting to OFF, press the
position.
After selecting the desired setting, press the
6
Step
PAUSE
Press the key to cancel the PAUSE mode.
Y
When the ROTATE setting is ON
X
Y
When the ROTATE setting is OFF
X
ROTATE
3
Step
F2/TEST
Press the
the menu below.
ROTATE
COPY
key (ON) to move the cursor to the ON
F1/ORIGIN
F2/TEST
key (OFF) to move the cursor to the OFF
ENTER
key to register your setting.
6 – 2
key (FUNCTIONS) to display