Expanding The Width Of The Plot Area - GRAPHTEC CE2000-60 User Manual

6.8 Expanding the Width of the Plot Area

The EXPAND function allows you to extend the width of the plot area by 9.5 mm on both sides for
a total 19-mm increase, thereby enabling you to perform cutting up to the area where the pinch rollers
are positioned.
1
Step
PAUSE
Press the key to enter PAUSE mode.
2
Step
Press the key until the menu below appears.
NEXT PAGE
FILM
FUNCTIONS
3
Step
After pressing the
EXPAND
4
Step
Press the key (EXPAND) to display the menu below.
F1/ORIGIN
ON
OFF
The blinking square cursor indicates the currently selected EXPAND setting.
5
Step
To enable the EXPAND mode, press the
To disable the EXPAND mode, press the
When the cursor appears in front of the desired setting, press the
setting.
6
Step
If you did not change the EXPAND setting in Step 5, press the
If you changed the EXPAND setting in Step 5, the menu below appears. This is the same menu for
selecting the media mode that appears whenever the medium has been reloaded.
ROLL 1
ROLL 2
Press the key (ROLL 1) or
F1/ORIGIN
roll medium you have just loaded.
key (FILM), press the
F1/ORIGIN
EXPAND
F2/TEST
key twice to display the menu below.
NEXT PAGE
key to move the blinking cursor to the ON position.
F1/ORIGIN
F2/TEST
key to move the blinking cursor to the OFF position.
PAUSE
key (ROLL 2) to select the media mode that suits the
6 – 12
ENTER
key to register your EXPAND
key to cancel the PAUSE mode.