GRAPHTEC CE2000-60 User Manual page 36

Replacing the Cutter Blade
1
Step
Turn the blade length adjustment knob
to retract the blade inside the plunger.
2
Step
Turn the plunger cap in the counter-clockwise direction to remove it from the plunger.
3
Step
Remove the blade from inside the plunger cap. In the case of the 0.9-mm blade, also remove the spring.
4
Step
Insert the new blade into the hole provided in the plunger cap. In the case of the 0.9-mm diameter
blade, insert the blade its the spring attached into the plunger cap.
5
Step
With the blade inserted in the plunger cap, screw on the plunger from above.
Blade length
adjustment knob (red)
Plunger for
1.5-mm dia. blades
1.5-mm diameter
cutter blade
1.5-mm
plunger cap
4 – 3
Blade length
adjustment knob (blue)
Plunger for
0.9-mm dia. blades
0.9-mm
cutter blade
0.9-mm
plunger cap
Spring