Specifying The Cutting Force - GRAPHTEC CE2000-60 User Manual

4.4.2 Specifying the Cutting FORCE

This setting determines the pressure to be applied by the cutter pen during cutting. Set the FORCE
value to suit the medium you will be using, based on the guidelines in the table entitled "Optimum Cutting
Conditions According to Film Type" on page 4-6.
1
Step
After selecting the desired set of cutting conditions, check that the cutting plotter is in READY or PAUSE
status and then press the
TEST CUT
PEN SETTINGS
2
Step
F2/TEST
Press the key (PEN SETTINGS) again to display the menu below.
SPEED
PEN FORCE
3
Step
F2/TEST
Press the key (PEN FORCE) to display the menu below.
PEN FORCE
12
At the above menu, use the
can be set in a range from 1 to 31 for the CE2000-60, and from 1 to 39 for the CE2000-120.)
When the displayed PEN FORCE value is satisfactory, press the
4
Step
Consecutively press the
F2/TEST
key to display the menu below.
and keys to change the PEN FORCE value. (The PEN FORCE
key until the READY or PAUSE menu reappears.
NEXT PAGE
ENTER
4 – 8
key to register your setting.