Mounting The Cutter Pen Plunger - GRAPHTEC CE2000-60 User Manual

4.3 Mounting the Cutter Pen Plunger

After the blade length has been properly adjusted, mount the cutter pen plunger in the cutting plotter
as described below.
1
Step
Loosen the pen holder's screw and
then mount the cutter pen plunger
into the pen holder.
2
Step
When the cutter pen plunger is properly positioned, tighten the
pen holder's screw.
3
Step
After the cutter pen plunger has been mounted, proceed to set the cutting conditions.
4 – 5
Be sure to press the
plunger in firmly so
that it contacts this
surface.