Specifying The Cutting Quality - GRAPHTEC CE2000-60 User Manual

4.4.5 Specifying the Cutting QUALITY

This setting determines the acceleration rate of cutting.
1
Step
After selecting the desired set of cutting conditions, check that the cutting plotter is in READY or PAUSE
status and then press the
TEST CUT
PEN SETTINGS
2
Step
F2/TEST
Press the key (PEN SETTINGS) again to display the menu below.
SPEED
PEN FORCE
3
Step
Press the key to display the menu below.
NEXT PAGE
CUTTER OFFSET
QUALITY
4
Step
CE2000-60
Press the F2/TEST key (QUALITY) to display the menu below.
QUALITY
At the above menu, use the
CE2000-120
NOTE : • The 2 setting can only be selected when the SPEED setting ranges from 1 through
30 cm/s. When the SPEED setting is 35 cm/s or higher, the QUALITY setting is fixed
to 1 (0.5 G).
• If you change the SPEED setting to 35 cm/s or higher while the QUALITY setting is
2, the QUALITY setting automatically switches to 1 even if you change the SPEED
setting to 30 cm/s or lower.
When the displayed QUALITY value is satisfactory, press the
When the SPEED setting is "∗∗" (the maximum speed), the QUALITY setting is also displayed as "**" and
automatically assumes a fixed value.
5
Step
Consecutively press the
F2/TEST
key to display the menu below.
1
or key to switch the QUALITY setting between 1 and 2.
key until the READY or PAUSE menu reappears.
NEXT PAGE
ENTER
4 – 11
key to register your setting.