Specifying The Special Functions - GRAPHTEC CE2000-60 User Manual

8.2 Specifying the Special Functions

1
Step
While holding down the
plotter. The menus for setting the special functions
will appear at the display panel.
In GP-GL command mode
3
Step
Press the
F1/ORIGIN
At the PARALLEL I/F menu, use the
When the desired setting is selected, press the
At this time, if you press the
the next special function menu without registering the setting you selected at the current menu.
4
Step
When all of the special functions have been satisfactorily set, turn off the cutting plotter.
key, turn on the cutting
ENABLE ":",";"
DISABLE COMD
PEN UP "W"
PEN DOWN
MANUAL SETTING
COMD PRIORITY
2mm BELOW INIT
OUTSIDE BLADE
ENABLE PEN UP
DISABLE MOVE
OFF MEDIA
ON SENSOR
OFF HOME
ON SENSOR
PARALLEL I/F
1
F2/TEST
or key to move the flashing cursor to the desired setting.
key without pressing the
NEXT PAGE
2
Step
Depending on the current COMMAND setting (GP-
GL or HP-GL), press the
the special function menus in the sequence shown
below.
In HP-GL command mode
or key to raise or lower the value.
ENTER
key to register your setting.
ENTER
8 – 4
key to cycle through
NEXT PAGE
7550 MODEL
7586 EMULATED
MANUAL SETTING
COMD PRIORITY
2mm BELOW INIT
OUTSIDE BLADE
ENABLE PEN UP
DISABLE MOVE
OFF MEDIA
ON SENSOR
OFF HOME
ON SENSOR
PARALLEL I/F
1
key, the cutting plotter displays