Testing The Gsm Module; User Settings - Visonic PowerMaster-10 Installer's Manual

5. PROGRAMMING
Option
SHOW ALL DEVICES
SHOW RF PROBLEMS

5.9.3 Testing the GSM module

The PowerMaster enable to test the GSM module integrated inside the panel.
06:DIAGNOSTICS
Enter the "GSM/GPRS" menu, and press
PowerMaster will present the test result.
The following table presents the test result messages
Message
Unit is OK GSM / GPRS is functioning correctly
GSM comm. loss GSM/GPRS module does not communicate with the Panel
Pin code fail Missing or wrong PIN code. (Only if SIM card PIN code is enabled.)
GSM net. fail Unit failed with registration to local GSM network.
SIM card fail SIM not installed or SIM card failure.
GSM not detected GSM auto enroll failed to detect GSM/GPRS module.
No GPRS service The SIM card does not have the GPRS service enabled.
GPRS conn. fail Local GPRS network is not available or, wrong setting to GPRS APN, user and/or password.
PowerManage receiver cannot be reached – Check the Server IP
Srvr unavailable
IP not defined Server IP #1 and #2 are not configured.
APN not defined APN is not configured.
SIM card locked After entering a wrong PIN code 3 consecutive times the SIM is locked. To unlock it enter a PUK
number. The PUK number cannot be entered by the control panel.
Denied by server PowerManage denies the connection request. Check that the panel is registered to PowerManage

5.10 User Settings

This USER SETTINGS menu provides you with a gateway to the user settings through the regular user menus.
Refer to the PowerMaster User's Guide for detailed procedures.
Caution! If after having programmed the user codes the system does not recognize your installer code, this
indicates you must have programmed a user code that is identical with your installer code. If so, access the user
menu and change the code that is identical with your installer code. This will re-validate your installer code
1
The signal strength indications are as follows: "STRONG"; GOOD"; "POOR"; "1-WAY" (the device operates in 1-way
mode or, the "NOW" communication test failed); "NO COM." (no communication); "NOT TST" (results are shown
without any performed test); "NOT NET" [device is not networked (not fully enrolled)]; "NONE" (keyfob 24Hr result); or
"EARLY" (result of the last 24Hrs without statistics).
56
Instructions
Press to test the selected device. The following screen will appear: "TESTING Zxx NNN".
While in the handheld devices test process, indicated by the corresponding display, for
example, "TEST KEYFOBS 01", press any key of the selected handheld device to initiate
the test.
At the end of the test process, the panel will present the devices' status: "Zxx:

24hr: <status>" 1 "Zxx: NOW: <status>"
Note: Refer to "SHOW ALL DEVICES" section for further information on device status.
You can view the devices status.
Note: This option is available only after testing process was done.
Press to view the devices' status.
The following screens will appear: "Zxx: 24hr: <status>"
Use to scroll between the device's families.
You can view only the devices which have RF problems.
Note: This option is available only after testing process was done.
Press to view the devices' status.
The following screens will appear: "Zxx: 24hr: <status>"
Use to scroll between the device's families.
  
GSM/GPRS
to initiate the GSM diagnostic test. Upon test completion, the
1
.

1 "Zxx: NOW: <status>"

1
"Zxx: NOW: <status>"
Description
D-303222 PowerMaster-10/30 G2 Installer's Guide
1
1