Panasonic KX-NCP500 Programming Manual page 66

2.6.1 Utility—Diagnosis
6.
From the CO Line Port No. drop-down list, select the port number of the trunk you want to test.
7.
Click Test.
The error report will be displayed.
8.
Select an option:
•
Click Capture if you want to save the displayed information.
1.
Enter a file name, or select a file to overwrite.
2.
Click Save.
•
Click Cancel to return to the Diagnosis screen.
Network Loopback Test
Performs a remote loopback test on the PRI23 card.
Note
•
To perform this test, it is necessary to set
—Port Property - PRI Port to "Enable".
•
The version of the PRI23 card must be 2.000 or later.
To perform a network loopback test
1.
From the Utility menu, select Diagnosis.
2.
Click on the Status cell of the PRI23 card, and set it to "OUS".
3.
Click on the cell showing the card type.
A new window will be displayed.
4.
Select the Loopback Type option.
A new window will be displayed.
5.
Select Point1 or Point2 depending on the type of loopback test you want to perform
The available selections may vary depending on the hardware version of the card.
6.
Click Apply.
Preparation for the test is complete. The test will start automatically.
7.
After the test is complete, select Release and click Apply.
8.
Click Close to return to the Diagnosis screen.
66 PC Programming Manual
Loopback Test started by Network in 3.35 [1-1] Slot