Panasonic KX-NCP500 Programming Manual page 18

1.2.1 Installing and Starting the Maintenance Console
4. a.
Enter the Installer Level Programmer Code (default: INSTALLER).
Note
There are 2 other Programmer Codes with limited authorisation: Administrator Level (default:
ADMIN), and User Level (default: USER). (® 1.2.2 Password Security)
b.
Click OK.
5. Click Connect.
6. a.
Select your PBX model from PBX Model.
b.
Select the LAN or RS-232C tab, depending on the type of PC connection with the PBX.
c.
Specify the settings as required. (See 2.1.1 Starting Maintenance Console and Software
Modes)
Note
When connecting to the PBX for the first time selecting LAN, the IP Address and Port
Number must be set to 192.168.0.101 and 35300 respectively.
d.
Enter the system password for installer (default: 1234).
e.
Click Connect.
7. When country/area data do not match:
a.
Click OK to replace the country/area data of the PBX. Replacement may take several minutes to
complete.
b.
Follow the procedure described in "3.13.1 Starting the PBX" (for KX-NCP500/KX-NCP1000),
"3.13.1 Starting the PBX" (for KX-TDE100/KX-TDE200), or "3.15.1 Starting the PBX" (for
KX-TDE600) in the Installation Manual and restart the PBX.
c.
Repeat step 5 to reconnect the Maintenance Console to the PBX.
8. Follow the instructions of the Quick Setup wizard for the basic items in Quick Setup.
9. On the IP addressing information screen, the information for the MPR card can be assigned
automatically through a DHCP server or entered manually.
Note
If you change any information on this screen and click Apply, the PBX will need to be reset.
When using a DHCP server:
a.
Select Enable for the DHCP Client setting.
b.
Click Apply.
Note
The boxes will turn grey and the IP addresses will
be assigned automatically after the PBX is reset.
18 PC Programming Manual