Panasonic KX-NCP500 Programming Manual page 231

SLT Pulse Minimum Make Width
Specifies the minimum length of the make signal in a pulse dial.
Value Range
8 ´ n (n=1–5) ms
Maintenance Console Location
3.23 [1-1] Slot—Card Property - Extension Type
Programming Manual References
None
Feature Guide References
None
SLT Flash Detection
Enables the PBX to detect the flash signal sent when an SLT user presses the hookswitch or the Flash/Recall
button.
Value Range
Disable: The PBX disconnects the line to prevent placing the call on hold.
Enable: The PBX places the call on consultation hold.
Maintenance Console Location
3.23 [1-1] Slot—Card Property - Extension Type
Programming Manual References
None
Feature Guide References
1.13.3 Call Splitting
Flash Timing - Min.
Specifies the minimum length that a signal sent from an SLT must be for the PBX to recognise it as a hookswitch
flash signal.
Value Range
8 ´ n (n=3–63) ms
Maintenance Console Location
3.23 [1-1] Slot—Card Property - Extension Type
3.23 [1-1] Slot—Card Property - Extension Type
PC Programming Manual 231