Panasonic KX-NCP500 Programming Manual page 421

Feature Guide References
1.5.4.4 Dial Type Selection
DTMF Width
Selects the length of the DTMF tone sent to the DID line.
Value Range
80 ms, 160 ms
Maintenance Console Location
3.50 [1-1] Slot—Port Property - DID Port (KX-TDE series only)
Programming Manual References
None
Feature Guide References
None
CO Pulse Speed
Selects the speed at which pulse dials are sent to the line.
Value Range
10 pulse/s, 20 pulse/s
Maintenance Console Location
3.50 [1-1] Slot—Port Property - DID Port (KX-TDE series only)
Programming Manual References
None
Feature Guide References
1.5.4.4 Dial Type Selection
Wink Signal Time Out
Specifies the length of time that the PBX waits to receive a wink signal after seizing a trunk. If a wink signal is
not received before this timer expires, the trunk is released.
Value Range
64 ´ n (n=1–128) ms
3.50 [1-1] Slot—Port Property - DID Port (KX-TDE series only)
PC Programming Manual 421