Panasonic KX-NCP500 Programming Manual page 934

13.1 [11-1] Main
Communication—NL Code
Specifies the NL (New Line) code for the printer or personal computer.
If the printer or personal computer automatically feeds lines with a carriage return, select CR (Carriage Return).
If not, select CR + LF (Line Feed).
Value Range
CR + LF, CR
Maintenance Console Location
13.1 [11-1] Main
Programming Manual References
None
Feature Guide References
1.26.1.1 Station Message Detail Recording (SMDR)
Communication—Parity Bit
Selects a parity bit code that indicates what type of parity is used to detect an error in the string of bits composing
a character.
Make an appropriate selection depending on the requirements of the printer or personal computer.
Value Range
None, Mark, Space, Even, Odd
Maintenance Console Location
13.1 [11-1] Main
Programming Manual References
None
Feature Guide References
1.26.1.1 Station Message Detail Recording (SMDR)
Communication—Word Length
Specifies the number of bits in each byte of a character.
When connecting the Maintenance Console to the PBX using an RS-232C cable, assign the following values
to the Serial Interface (RS-232C) port of the PBX:
Word Length: 8 bit, Parity Bit: None, Stop Bit: 1 bit
Notice
Do not use the following combinations:
•
Word Length: 8 bit, Parity Bit: Space, Stop Bit: 1 bit
•
Word Length: 8 bit, Parity Bit: Mark, Stop Bit: 2 bit
934 PC Programming Manual