Scanner Cr Encoder Board - Epson Artisan 700 Service Manual

Epson Artisan 700/Epson Stylus Photo PX700W/TX700W

4.2.5.4 Scanner CR Encoder Board

Parts/Components need to be removed in advance:
Scanner Unit/ADF Unit/Scanner Upper Housing
Removal procedure
1. Disconnect the Scanner Motor cable from the connector on the Scanner CR
Encoder Board. (See 4.2.5.2 Scanner Motor Unit Step1
2. Disconnect the Scanner CR Encoder FFC from the connector (CN1) on the
Scanner CR Encoder Board.
3. Loosen the screw that secures the Scanner CR Encoder Board to the Scanner
Lower Housing, and remove Scanner CR Encoder Board from the Scanner
Lower Housing.
Scanner CR Encoder Board
C.B.S. 3x8 (5±1kgfcm)
Figure 4-172. Removing the Scanner CR Encoder Board
DISASSEMBLY/ASSEMBLY
(p168).)
CN1
Scanner CR Encoder FFC
Rib
Disassembly Procedures
When routing the Scanner CR Encoder FFC of Artisan 800/
PX800FW/TX800FW, route it as shown in
See Fig. 4-171 and below for Artisan 700/PX700W/TX700W.
Scanner CR Encoder FFC
Artisan 700/PX700W/
TX700W
Figure 4-173. Routing the FFC
(Artisan 700/PX700W/TX700W)
Revision C
Fig. 4-168 and Fig. 4-172.
Rib
172
Confidential