SMART Room System Setup And Maintenance Manual page 66

A P P E N D I X A
Using the interactive flat panel on-screen display menu
Option
MONITOR INFO
MODEL NAME
SERIAL NUMBER
OSD TRANSPARENCY
OSD RESET
SETUP
POWER SAVE
STANDBY MODE
DDC CI
SCAN MODE
FBC CONTROL
MONITOR ID
PROXIMITY CONTROL
PROXIMITY
RE-ENABLE TIME
AUTO POWER OFF
BRIGHTNESS
60 smarttech.com/kb/170450
Values Function
[N/A] Shows the interactive flat panel's
model number
[N/A] Shows the interactive flat panel's
serial number
TYPE1 Sets the on-screen display menu
transparency
TYPE2
OFF
[N/A] Resets all options in the OSD
menu to their default values
ON Enables or disables Power Save
mode
OFF
STANDBY Sets the Standby mode to reduce
power consumption
ECO
STANDBY
ENABLE Enables or disables two-way
communication and control of the
DISABLE
interactive flat panel
UNDER SCAN Sets the scanning mode
OVER SCAN
ENABLE Enables or disables the front
control panel
DISABLE
1–100 Sets the interactive flat panel's ID
ENABLE Enables or disables presence
detection
DISABLE
1–10 Sets how long the interactive flat
panel waits before detecting
motion again (in minutes)
15–240 Sets when the interactive flat panel
automatically turns off (in minutes)
0–100 Sets the brightness of the welcome
screen
Notes (if any)
This option only provides
information. You're unable to
modify it.
This option only provides
information. You're unable to
modify it.
Don't change this option from its
default value.
Don't change this option from its
default value.
This option isn't applicable to the
SMART Room System. Don't
change it from its default value.
This option isn't applicable to the
SMART Room System. Don't
change it from its default value.
Don't change this option from its
default value.
This option isn't applicable to the
SMART Room System. Don't
change it from its default value.
You can modify this option only if
you select STANDBY in
STANDBY MODE.
You can modify this option only if
you select ENABLE in
PROXIMITY.
You can modify this option only if
you select ENABLE in
PROXIMITY.
This option isn't applicable to the
SMART Room System. Don't
change it from its default value.