Section 3 Maintenance And Adjustment Of Vehicle Body; (I) Wear Inspection Of Front And Rear Brake; (Ii)Adjustment Of Front Brake - ATV 200 Service Manual

Section 3 Maintenance and Adjustment of Vehicle Body

(I)Wear inspection of front&rear brake
1.Check the front brake
(1)Brake the vehicle with front brake
(2)Check:
.Wear indication ¢Ù
.If the wear indication reach the wear limit mark
¢Ú ,replace the brake shoe assy.
Refer to section"Front wheel and front brake"in
chapter VII.
¢Ù
¢Ú
2.Check the rear brake
(1)Thread down the rear brake pedal to brake
the vehicle.
(2)Check
.Wear indication ¢Ù
.If the wear indication reach wear limit mark
¢Ú ,replace the brake shoe assy.
Refer to section "Rear wheel and rear brake"in
chapter VII.

(II)Adjustment of front brake

¢Ù
¢Ú
Caution
Before adjusting, check the wear degree of
front brake according to above procedures.
Caution
In order to avoid too large or too small brake
force when braking, must ensure the proper free
clearance of right brake lever and rear brake
pedal:
1.Check
If the free clearance of right lever does not con-
form to specification as shown in figure, ad-
just it according to the following standard.
Standard free clearance of right lever:5-7mm
Calculate from the fulcrum.( in figure)
- 39 -