ATV 200 Service Manual page 13

Fig.7.5
Fig.8.1Tightening method of screw and nut.
b. If joint is slack, bend the plug pin
upward, then connect with connector plug(see
fig7.5)
7.6 Before mounting new fuse, check if
the load of fuse of components is right, espe-
cially for the portion being burned broken
regularly, then mount the fuse having proper
current value.
7.7Wire connector have two kinds, one
is single-head connector, another is multi -head
one.
Before connecting single-head connector
,check if there is broken on the housing of
joints, the joint is fixed and if there is a broken
phenomenon on it. When inserting the joint, it
should be fixed, then put in plastic coating af-
ter inserting.
In general, multi-head connector is plas-
tic one, and locking catch is designed. When
disassembling the connector, first open lock-
ing catch when connecting again, first check
if all the joint is in good condition, if there is
bent or twist on them. After connecting, align
the locking catch and lock them.
8. Use torque spanner to tighten screw
and nut, and as per specified torque to tighten
them. It should be tightened in steps from big
ones to small ones, from inside to outside and
along the direction of diagonal line to intersect.
A s shown in fig.8.1.
- 7 -