ATV 200 Service Manual page 172

- 166 -
If out of specification, rebore or replace the
cylinder and piston (Replace in a set)
.Measure the diameter "P"of piston lower part
with micrometer, is the measuring position
is 4mm away from piston bottom(0.16 in)
Piston lower part diameter "P"
Standard 62.94~62.96mm
If out of specification. replace the piston and
piston ring as a set at the same time.
.Calculate the mating cylinder clearance with
the following formula
Mating cylinder clearance= "C"- "P"
Inner diameter of cylinder"C"
Piston lower part diameter "P"
Mating cylinder clearance: 0.035~0.06mm
(0.0016~0.0024 in)
Limit:
0.15mm(0.06 in)
.If out of specification, rebore or replace the
cylinder, and replace the piston and piston ring
as a set at the same time
15.Piston ring and piston pin
Piston ring
1)Measure
.Clearance between piston ring and ring groove
.Use feeler gauge ¢Ù
If out of specification, replace piston and a set
of ring
Caution
First clean the carbon deposits inside the pis-
ton ring and ring groove, followed by measur-
ing the clearance between piston ring and ring
groove.