ATV 200 Service Manual page 183

30.Hand operated mechanism
1)Inspection
If cracks beat,damaged,replace it.
.Driving jaw
.Compressing spring
.Torsion spring(Driving jaw position)
Wear/cracks/damage,replace it.
2)Inspection:
.Rolling spring(Starting)
Wear/cracks/damage,replace it.
.Tension wire
Wear/cracks/damage,replace it.
.Driving plate assy
Cracks/damage,replace it.
31.Output mechanism
1)Inspection
.All gears
If pressing mark/abrasion/wear is found,replace
it
.Connecting jaw
If pressing mark/abrasion/wear is found,replace
it
.Driving shaft
.Output shaft
If damaged or bent,replace it.
Caution
When replace any gear or output shaft,be sure
to readjust core gear washer,refer to¡± Selec-
tion of adjusting washer¡± section.
2)Inspection
.Bearing
If pressing mark or abrasion is found,replace
it.
3)Inspection
.Front joint and rear joint
.Driving fork
.Needle bearing
- 177 -