ATV 200 Service Manual page 184

- 178 -
4)Inspection
.Reverse fork
If wear/abrasion/bend/damage is found on the
surface connecting with connecting jaw and re-
verse operating shaft,replace it.
.Compressing spring
If the elasticity is lost,or worn replace it
.Steel ball
If wear,damage,or scratch marks is found,re-
place it
5)Inspection:
Reverse fork shaft
Roll the reverse fork shaft on the flat surface,
if bent,replace it.
Caution
Never straighten a bent shaft and reuse it
6)Inspection
.Flexibility of fork movement
Install the reverse fork to forkshaft,if not ac-
tive or smooth in operation,replace fork and fork
shaft.
7)Inspection
.Reverse control lever
.Operating plate
.Reverse operating shaft
If bend,cracks or damage is found, replace it.
8)Inspection
.Rear cover
If cracks or damage on the position connecting
with left crankcase,rear driving cover is found,
replace the rear cover.
.O-ring
If damaged or deformed,replace it
Caution
When replacing the rear cover,be sure to re-
adjust the gear core washer,refer to"Selection
of Adjusting washer"section.