(Iii)Trouble-Shooting Table - ATV 200 Service Manual

to check the rust of bearing which will cause jam.
Caution
A little metal corpuscle in oil is normal.
3. Check the oil leakage
Check according to following procedures.
a.Clean the whole vehicle totally, then wipe and dry it.
b.Paint inspecting solvent of oil leakage or dry powder on the transmission shaft
c.Only enough examining distance (Suggestion
If leaking-check component.
If damaged-replace component
Caution
1.The oil leakage of new or newer vehicle is caused by improper installation of oil seal or damage of oil
seal.
2.To the part you doubt the oil leakage, must check and confirm carefully to avoid unnecessary
disassembly.

(III)Trouble-shooting table

If there is basic trouble condition, check following points.
Rise up and rotate the front
wheel to feel if the front wheel
bearing is damaged.
Check the rear wheel shaft to
feel if the bearing is damaged
Remove the rear wheel shaft,
and check if the bearing is
damaged
Remove the transmission shaft
components
- 68 -
¡Ý 5km)can ensure to examine the leakage.
Replace the front wheel bearing (Refer to
"Front wheel and front brake"of this
chapter)
May be no damage of rear wheel shaft
bearing and driving shaft bearing. Recheck
it or remove single component.
Replace the rear wheel shaft bearing (Refer
to "Rear wheel and rear wheel shaft"of this
chapter)