ATV 200 Service Manual page 104

2.Lubricate the steering vertical column holder
¢Ùand seal ring ¢Úduring installing the steer-
ing vertical column welding.
3.Installment
Install the seal ring ¢Ùto the steering vertical
column welding, then install bushing¢Ú, finally
install the steering vertical column holder¢Û.
Caution:
Never damage the seal ring when installing.
4.Installment
When installing the steering vertical column
holder and steering vertical column welding take
them as unit ¢Ù .
Warning
In order to ensure the correct circuit of brake
cable and wire, never damage and wind the
cables and wires.
5.Installment of left and right tension rod¢Ú
Caution
Make sure that the ball pin at the side of
scraped marking connect with the front seat
assy of front brake.
6.tighten up the nut of ball pin assy.
Attached:Nut torque :25Nm
- 98 -