ATV 200 Service Manual page 94

8.Inspection(The Ser.No as shown on the
drawing)
¢ÙInner surface of rear brake hub
If there is some engine oil or scraped markings,
remove it and treat it ,the method of treat is as
the follows.
Removal of engine oil:Clean with cloth dipped
in volatile diluent or volatile solvent.
Removal of scraped marking:Wipe slightly and
with even force the scraped marking till to re-
move it.
¢ÚGear groove of rear brake hub
If worn or damaged, replace it.
9.Inspection
¢ÙIf there is some cracks, bend or damage
on the brake cover, replace it.
¢ÚIf the dust-proof seal is worn or damaged,
replace it.
10.Inspection
¢ÙIf there is worn scraped marking or dam-
age on the cam shaft of rear brake, replace it.
¢ÚIf the air pipe of rear brake is clogged, re-
move this pipe and clean the dirt, if damaged,
replace it.
11.Clean the air hole on the rear brake cover
with compressed air.
12.Inspection of rear wheel axle ¢Ù
a:If the rear wheel axle is heavily scraped or
broken, replace it.
b.If the thread or gear groove on the rear wheel
axle is worn or damaged, replace it.
- 88 -