ATV 200 Service Manual page 95

13.Measurement
The radial runout of the position @on the rear
wheel axle is:0.2, if out of specification, repalce it.
Attached:The radial runout limit of rear wheel
axle:0.5mm
Warning
If the axle is bent, do not straighten it forcefully.
14.Inspection:
¢ÙBearing on the rear wheel axle
Rotate the rear wheel axle, if the axle shakes
left and right in the bearing or runout axially,
It indicated that the bearing is heavily worn
needing to be replaced.
¢ÚIf the oil seal is worn or damaged, replace
it.
Replacement steps of bearing and oil seal:
a.Clean around the bearing of gear case end.
b.Remove the oil seal ¢Ùwith plain
screwdriver.
Caution
In order to protect the oil seal out edge from
damage during the removal process, place a
wood block ¢Úunder the screwdriver.
Remove the bearing ¢Ûwith corresponding
tool.
The installment of new bearing and oil seal is
in reverse.
Caution
During the installment, the pressing tool of
bearing ¢Üshould be matched with the outer
diameter of bearing outer race ¢ßand that of
oil seal.
Warning
Never beat the inner race ¢Ýand bearing ball
¢Þ , the pressing tool needs to touch with bear-
ing outer race ¢ß .
- 89 -