ATV 200 Service Manual page 60

- 54 -
3.Remove
a.Air filter core ¢Ù
b.Foam supporting cylinder¢Ú
Caution
Never start the engine without filter, other-
wise the piston and cylinder will be overworn.
4.Inspect
a.Air filter core ¢Ù
b.Form supporting cylinder¢Ú
If damaged, replace it.
5.Clean foam supporting cylinder. Clean off
the dust on the inner surface of the foam sup-
porting cylinder with compressed air.
6.Clean the foam filter core:
a.Clean with water completely and slightly.
b.Squeeze the surplus water of the foam and
dry it.
Note:
When squeezing the water on the foam, be
sure to be slight.
7.Install:
a.Install the foam filter core to the foam sup-
porting cylinder to combine a air filter assy.
b. Install the air filter assy.
c.Install the air filter cover.
Caution
Make sure that the close fit surface of air fil-
ter is engaged with the close fit surface of air
filter box, and the air leakage is not allowed.
9.Installt cushion(refer to Section Two "Cush-
ion Installment"of this chapter)