ATV 200 Service Manual page 209

¢Ú
¢Ý
60Nm
¢Þ
¡¤ Turn the crank until the mark TDC ¢Û is cor-
respondence with the mark on the crankcase
cover ¢Ü .
¡¤ Mount the timing chain to the timing sprocket
pulley.
¡¤ Mount the timing sprocket pulley to the cam
shaft for ensuring the mark of timing sprocket
pulley ¢Ý is correspondence with the mark ¢Ú
on the cylinder head, then fasten the sprocket
pulley bolt with hand.
(Be ensure the tension of the timing chain at
the outlet when mounting the timing sprocket
pulley)
¡¤ Insert the special tooling into the tension hole
of timing chain and pull the tensioner timing
chain toward inside.
¡¤ The matching mark ¢Ý of timing sprocket is
sure to correspond to the matching mark ¢Ú of
cylinder head when pulling the timing chain
tensioner.
¡¤ Change the matching position between
sprocket pulley and chain if the marks is not
aligned.
¡¤ After the marks is aligned, fasten the bolt
of timing sprocket.
Caution
Fix the starting ratchet ¢Þ and tighten the bolt
of timing sprocket .
17. Mount:
Tensioner of timing chain
Mounting steps:
¡¤ Take off bolt ¢Ù from the tensioner of tim-
ing chain.
- 203 -