Section 3 Maintenance And Adjustment Of Vehicle Body; (I) Wear Inspection Of Front And Rear Brake; (Ii)Adjustment Of Front Brake - ATV 250 Service Manual

Section 3 Maintenance and Adjustment of Vechicle Body
(I)Wear inspection of front&rear brake
1.Check the front brake
(1)Brake the vehicle with front brake
(2)Check:
.Wear indication ¢Ù
.If the wear indication reach the wear limit mark
¢Ú ,replace the brake shoe assy.
Refer to section"Front wheel and front
brake"in chapter VII.
¢Ù
¢Ú
2.Check the rear brake
(1)Thread down the rear brake pedal to brake
the vehicle.
(2)Check
.Wear indication ¢Ù
.If the wear indication reach wear limit mark
¢Ú ,replace the brake shoe assy.
Refer to section "Real wheel and real brake"in
chapter VII.

(II)Adjustment of front brake

¢Ù
¢Ú
Caution
Before adjusting, check the wear degree of
front brake according to above procedures.
Caution
In order to avoid too large or too small brake
force when braking, must ensure the proper
free clearance of left/right brake lever and rear
brake pedal:
1.Check
If the free clearance of right lever does not
conform to specification as shown in figure,
adjust it according to followig standard.
Standard free clearance of right lever:5-7mm
Calculate from the fulcrum.( in figure)
-39-