Section 3 Maintenance And Adjustment Of Vehicle Body; (I) Wear Inspection Of Front And Rear Brake; (Ii) Adjustment Of Front Brake - ATV ATV110-M Service Manual

Section 3 Maintenance and Adjustment of Vechicle Body
(I) Wear inspection of front&rear brake
1. Check the front brake
(1) Brake the vehicle with front brake
(2) Check:
.Wear indication
.If the wear indication reach the wear limit mark
,replace the brake shoe assy.
Refer to section"Front wheel and front brake"
2. Check the rear brake
(1) Thread down the rear brake pedal to brake
the vehicle.
(2) Check the dick friction pad to see if it
reaches the life-spin
Replace it whenever ne cessary.

(II) Adjustment of front brake

Caution
Before adjusting, check the wear degree of
front brake according to above procedures.
Caution
In order to avoid too large or too small brake
force when braking, must ensure the proper
free clearance of left/right brake lever and rear
brake pedal:
1. Check
If the free clearance of right lever does not
conform to specification as shown in figure,
adjust it according to followig standard.
Standard free clearance of right lever:5-7mm
Calculate from the fulcrum.( in figure)
-26-