ATV 200 Service Manual page 126

8.Resistance value of charge coil
.Remove the corresponding connector of charge
coil from cable.
.Connect the multimeter(
of charge coil
Multimeter pen (+) ¡ú yellow/green wire end ¢Ù
Multimeter pen (-) ¡ú yellow/green wire end ¢Ú
Inspect if the resistance value conform to speci-
fication
Coil resistance value
At
20¡æ (68¡ãF)450~550¦¸
Conforming to specification
Correct
replace CDI assy
- 120 -
¡Á100 ) to wire end
¦¸
Not conforming to specification
Poor connect
Connect the ignition system correctly
Replace charge coil